Honeywell Dolphin 7600/7850 Installation and Configuration Notes

Installing and configuring the Honeywell/HandHeld 7850 and 7600 series mobile devices is quick and easy.

Installation Notes

• .NET Compact Framework – Windows Mobile 6 versions have .NET CF 2.0 already installed, but the installer will try to install it anyway. You may simply cancel the installation of .NET CF 2.0.
• SqlCE – After SqlCE is installed, you will probably asked to reboot your device. Please do so and wait until the device reconnects before continuing.

Configuration Notes

• Configure Scanner – Check the scanner configuration by going to Start > Power Tools > EZConfig Utilities > ScanWedge. When the ScanWedge applet comes up, go to Scanwedge > Settings as shown:

  

  Check the following settings:

  • Ensure that PrefixKeys is enabled and its value is 12.
  • Ensure that SuffixKeys is enabled and its value is 13.
  • Ensure that SendMode is enabled and its value is Virtual Keys.

  Next, click VKMapping and add insert a new key for 12, as shown, if not already present:

  

• Launch Scanner – Lanch the ScanWedge scanner applet by going to Start > Power Tools > ScanWedge. Note, you will need to restart the ScanWedge application anytime you make a change to the ScanWedge settings.

  

• Symbology Specific Settings – Depending on your labels, you may also need to check the settings for individual symbologies. From the ScanWedge setings, click Sybologies.

  

• Retail Mobile Suite Settings – On your device, go to Device Configuration > Wedge. Click Reset. Scan a barcode. This step trains Retail Mobile Suite as to which buttons on the device initiate scans.